SHOCK NITROGEN GAUGE

TSNG 02

 
The Flare Nut Coupling works with TSNH 048 Hose. This "finger tight" fitting can handle 800 psi. 
 
The fitting can be changed out for a different one if needed for your system.

CHARGING PROCEDURE
 
1- Compress the shock shaft before charging. This will extend when pressurized and indicates the shock is filling.
 
2- Attach the Nitrogen Gauge to the Schrader valve on the shock using the Main Attachment Knob.
 
3- Depress the valve core by screwing in the Valve Core Depressor knob.
 
4- Set the regulator higher than the required pressure. Open the ball valve to pressurize. The shock shaft will extend.
 
5- Once the pressure is higher than required, shut the ball valve.
 
 

 

 
6- Set the correct pressure using the Bleed Valve. The Bleed Valve looks like a Schrader Valve but the cap has been modified to release pressure slowly.
 
7- Unscrew the Valve Core Depressor.
 
8- Release the remaining pressure in the Gauge with the Bleed Valve.
 
8- Remove the Gauge from the shock.
 

 

 

TSNR 01 NITROGEN REGULATOR

TSNH 048 HI-PRESSURE QUICK CONNECT HOSE

TSNC 02 WP CHARGING

 
Nitrogen Charging Equipment Available from RT
  - TSNG 02 - Shock Nitrogen Gauge
  - TSNN 01 - Nitrogen Needle
  - TSNR 01 - Regulator
  - TSNH 048 - High-pressure Nitrogen Hose
  - TSNC 02 - WP Charging Tool
  - SPNV 012 - M5 Charging Bolt

Nitrogen tanks are available in many sizes at welding supply stores.

 
 

TSNN 01 NEEDLE
 
SPNV 012 CHARGING BOLT