SK INSTALL G3S TRIUMPH TIGER 1050 2007

G3-S Mounting Instructions

Triumph Tiger 1050 (2007-Current)

These are instructions for mounting the shock to the motorcycle. The shock has been preset for your weight, skill, and riding type.  The preset adjustments are listed on your Setup Sheet.

After mounting the shock please check the Sag. Click here for details.

Click here for General G3-S Instructions.

Note: Click on the images to enlarge.

1.    Remove stock Shock Absorber according to your Triumph Owners Manual.

2.    With the Linkage Arm dropped down as shown feed the remote reservoir through the bottom of the Swing Arm followed by the G3-S Shock absorber. The reservoir hose will face the left side of the motorcycle
 

3.    Once in place push the upper shock Bolt through the upper mount and torque to factory specifications.

4.    Attach the Lower Linkage Arms and Shock Bolt. Torque to factory specifications.

 

5.    Place included Reservoir Clamps and Rubber Pads to attach the Remote Reservoir to the Sub-Frame as shown. Hose Clamps should be spaced as far as possible with the Rubber Pads placed between the Reservoir and Frame Rail beneath the Hose Clamp. Tighten clamps so that the reservoir will not move under any riding conditions.

Have fun! Go Ride!

The shock is preset for you. Please check the sag before you ride.