TSDY CPH956075

3/8" Dyno Clevis Pin is used with the Shock Eyelet and Clevis Mounts.

TSDY FAMB01

Lower Fork Base is used with Fork Axle Sleeves (see below) to mount single or dual tubes

Fits on 5/8"-18 UNF threaded post with a nut

TSDY FAM Series

Axle Sleeves are available as 3 part sets. All three parts are the same OD and different on the ID:

One is non-threaded. It is used in the middle of a dual leg setup.

The second has a recess for the Allen Bolt Head. It is used in a dual leg setup.

The third is threaded on both ends. It is used by itself for single leg mounting (shown below). It is also used in dual leg mounting on the outside.

Here is a cross section view of a Dual Fork Leg Setup.

Note - The Upper Dual Fork Mount is required for dual setup.

Most forks require two different diameters to mount a pair of fork tubes.

TSDY FAM20 - 20mm

Complete Set

Or save a bit and get the complete set including all 8 sets (24 sleeves) listed above.

TSDY FAMS01 20-32mm

SINGLE FORK LEG SETUP

This is a combination of:
Lower Fork Base - TSDY FAMB01 and
a single Fork Axle Sleeve - TSDY FAM Series

DUAL FORK LEG SETUP

This is a combination of:
Lower Fork Base - TSDY FAMB01 and
two Fork Axle Sleeve Sets - TSDY FAM Series (two, because the left and right are usually different diameters).

TSDY FAMB02

The MTB Adapter clamps onto the fork axle.

It fits 12 - 20mm axles, 0 - 70mm offsets (the cycling world often calls it rake).

Requires a Lower Fork Base - TSDY FAMB01 (shown)

TSDY FTMB64

The Upper Fork Base is used along with a Fork Tube Bushing (see below) to mount complete fork legs on the dyno.

Uses 64mm OD Bushings

5/8"-18 UNF thread

TSDY FTB Series

Fork Tube Bushings are available individually and used with the Upper Fork Base.

Bushings are 64mm OD

TSDY FTB28664 28.6mm (1 1/8") MTB -

Complete Set

Or save a bit and get the complete set. Includes all 9 sleeves listed above.
TSDY FTBS6401 28.6-57mm -

TSDY FTB2T

The Upper Dual Fork Mount allows a pair of tubes to be mounted at the same time.

This is particularly useful for forks with compression on one leg and rebound on the other.

Requires two Upper Fork Bases and Tube Bushings.

DUAL FORK MOUNT ASSEMBLY

(WITH UPPER FORK BASES AND BUSHINGS)

You will need to purchase two Upper Fork Bases (TSDY FTMB64) and the appropriate Upper Fork Tube Bushing (TSDY FTB Series).

TSDY SCM01

The Shock Clevis Mount has a 19mm threaded post.

The base has a taper to help center wider clevises.

5/8"-18 UNF thread

TSDY SEM3410

The Shock Eyelet Mount has a 43mm cutout width. It fits most shocks with eyelets.

The brass pin pushes down on the eyelet to take up slop in the heim bearing.

A second Shock Eyelet Mount is required for shocks with dual eyelets.

5/8"-18 UNF thread